Electrolux ZUCA1 Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Посудомийна машина Electrolux ZUCA1. Electrolux ZUCA1 14 сторінок.
Друкувати сторінку
Amount of detergent during the cycle:
dEt
Setting the activation time:
8
1
2
Amount of rinse-aid during the cycle:
rAl
Setting the activation time:
4
1
2
Exit from programming mode:
Notes for external dispensers:
-
if
the detergent dispenser only ope-
rates during wash pump operation; terminals 7-9
of the main terminal board are powered at the
same time.
-
if
the detergent dispenser only ope-
rates during filling electrovalve operation for res-
toring the boiler level; terminals 7-9 of the main
terminal board are powered at the same time.
-
if
the rinse-aid dispenser only opera-
tes during filling electrovalve operation for resto-
ring the boiler level; terminals 8-9 of the main
terminal board are powered at the same time.
-
if
the rinse-aid dispenser only opera-
tes during wash pump operation; terminals 8-9 of
the main terminal board are powered at the same
time.
For connections, see the wiring diagram.
Example:
Supposing that an external detergent dispenser has
been connected with a tank concentration measuring
sensor, a standard setting could be as follows:
the dispenser is not activated during filling of
the tank.
the dispenser is activated during wash
pump operation and, thanks to the concentration
measured by the conduction sensor, the correct
amount of detergent is dispensed.
8
1
2
3
4
1
2
3
GEn
2) Rinse-aid diaphragm dispenser
To change the dispensed amount, turn
"D" accordingly (Figure 16).
Suggestion: to check the effectiveness of the rinse-
aid, look at freshly washed glasses against the light.
Drops of water remaining on the glass indicate an
insufficient amount while streaks indicate an excess.
Changing the detergent/rinse-aid type.
If changing to a different detergent/rinse-aid type
(even one by the same manufacturer), you must rinse
the suction and pressure hoses with fresh water before
connecting the new detergent/rinse-aid container.
Otherwise, the mixing of different types of detergent/
rinse-aid will cause crystallisation, which may result in
a breakdown of the dosing pump. Failure to observe
this condition will invalidate the guarantee and product
liability.
B5
MAINTENANCE
•
Descale the boiler, the internal surfaces of the tank
and the appliance water piping once or twice a
year.
•
Descale the rinse and wash jets every month using
vinegar or a descaling agent.
•
The internal hose of the rinse-aid and detergent
peristaltic dispenser should undergo periodic main-
tenance (once or twice a year).
Prolonged period of inactivity
If the dishwasher is not to be used for a long time, pro-
ceed as follows:
•
Close the water supply valve.
•
Completely drain the tank.
•
Remove and carefully clean the filters.
•
Completely
drain
the
hoses, removing them from the containers. Repeat
the procedure described in the paragraph "Manual
activation" at least 3 times.
•
Completely drain the boiler.
•
For atmospheric versions only: completely drain the
boiler by simultaneously pressing the buttons as
shown in the figure.
A buzzer indicates completion of drainage.
•
Spread a thin film of Vaseline oil over all the stain-
less steel surfaces.
on screw
incorporated
dispenser
1
2
3
11