Dreamline ENIGMA-Z SHDR-62607610 Series Інструкція з монтажу Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Сантехнічний виріб Dreamline ENIGMA-Z SHDR-62607610 Series. Dreamline ENIGMA-Z SHDR-62607610 Series 20 сторінок. Shower door & tub door
3.
Attach the Upper guide rail (#03) to the Stationary glass (#02)
with the Glass brackets (#07) and tighten the bolts into the
pre-drilled holes in the Upper guide Rail (#03). Make sure both
adjustment disks are installed in the same direction with the high spot
towards the door end (see *NOTE below). Make sure the guide rail is
parallel with the top edge of the glass (see Fig. 4).
(EQ=Equal distance)
Slide the Door stoppers (#01) onto each end of the Upper guide rail
(#03) and secure them temporarily using the 4mm hex wrench (#11).
Slide the Guide Rail brackets (#08) onto each end of the Upper
guide rail (#03) and temporarily secure them as well. Next, assemble
the Wall Bracket (#19) onto the bottom corner of the Stationary
glass (#02) as shown in Fig. 3.5. Use the provided gaskets to protect
the glass.
glass bracket
adjustment
disk
*NOTE:
The outer glass bracket disk has an eccentric bushing
for adjustment. Be sure to install both glass bracket disks with
the high spot of the bushing pointed towards the door end of
the guide rail. See the detail of the disks below as viewed from
inside prior to installing on the glass.
High spot of disk bushing
ENIGMA-Z manual Ver 1 Rev 4 10/2016
See Fig. 3 and Fig. 4 for details
after adjusting the
disk, use this hole to
hold it in place with
a small allen wrench
Door end of guide rail
1
3
5
outside
Fig. 3
EQ
measure
Fig. 4
2
4
6
9