ANDI ACIF682 Інструкція з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Варильна поверхня ANDI ACIF682. ANDI ACIF682 13 сторінок. Induction hotplate

Installation

Selection of installation equipment

Drill holes on the table surface according to the sizes shown in the

drawing. For the purpose of installation and use, a minimum of 50 mm

space shall be preserved around the hole.

Be sure the thickness of the table surface is at least 30mm. Please

select heat-resistant table material to avoid larger deformation caused

by the heat radiation from the hotplate.

As shown in Figure (1)

Under any circumstances, make sure the induction hotplate is well

ventilated and the air inlet and outlet are not blocked.

Ensure the induction hotplate is in good work state. As shown in

Figure (2)

mini 2 cm

Air intake

Note: The safety distance between the hotplate and the cupboard above the

hotplate should be at least 650mm.

mini 650mm

Air exit

mini 5 cm

mini 5 mm

Figure (1)

Figure (2)