andover SPINSTAND Посібник з монтажу - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з монтажу для Стелажі та підставки andover SPINSTAND. andover SPINSTAND 11 сторінок. Component & record rack

Друкувати сторінку

Anti-Tip Kit installation

IMPORTANT NOTE: An Anti-Tip Strap is

included with your

Spinstand.

Please use it

whenever Spinstand is installed in a location

where it may tip and cause physical

harm.

Drywall inserts {Item 23) and screws {Item

22) are included with this kit, but may not

be suitable for every type of wall. It is your

responsibility to supply wall mounting

hardware suitable for the specific wall con-

struction of your home. It is best to locate

the Spinstand such that the Anti-Tip bracket

may be screwed directly into a wall stud

whenever possible.

Once Spinstand is in position, locate

the second Bracket (Item 20} at the

approximate height of the top shelf and

centered relative to the stand.

Mark

the

location of the two screw holes with a

pencil.

2. Drill suitable pilot holes for your pre-

ferred wall anchors at the marked posi-

tions.

If you use the anchors we supply,

use 1/4" drill bit. Install the anchors and

attach the remaining bracket. Anchors

are not needed if the bracket can be

attached to a stud. An 1 /8" drill should

be used for pilot holes in a stud.

Loop the Anti-Tip strap {Item 24}

through both brackets and insert the tip

of the strap through the latching end,

forming a closed loop. Check to make

sure the latch is secure and will not slip

open.

Page 10