Electrolux EFC 6420 Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Вентиляційна витяжка Electrolux EFC 6420. Electrolux EFC 6420 15 сторінок. Electrolux cooker hood
Також для Electrolux EFC 6420: Посібник користувача (15 сторінок), Посібник користувача (15 сторінок), Посібник користувача (15 сторінок)
Друкувати сторінку
Installation
Wall unit mounting - Fig. 9
Disconnect the hood during electrical connection, by turning the home mains switch off.
• Rest the suction unit on a flat surface and thread the lower part of the hood onto it (1).
• Make all the electrical connections between the two parts (2).
• Fasten the hood to the suction unit using 8 screws (3).
• Sign the wall with a center line, this will aid mounting procedure (4), position the template so that the mid line
printed on the template matches with the center line previously signed, the lower side of the template
corresponds to the lower side of the hood once mounted (5).
• Drill two holes Ø 8mm and fix the support bracket with two wall plugs and screws (6).
• Hang the hood (7) adjust its position (8-9) and from the inside of the hood sign one point for definitive fixing
(10), remove the hood (11) and drill an hole Ø 8mm (12), fit a wall plugs (13).
• Drill two holes Ø 8mm on the upper side
close to the ceilling (14), fit two wall
plugs and fix the chimney support
with two screws (15).
• Hang the hood again
(16).
• Fix it definitively with a
screw (17). To
simplify the mounting
operation remove the
carbon filter frame.
• In case the hood is to
be used in filter
version, mount the
deflector F on the
chimney support G
with four screws
2,9x6,5 and fit an
exhausting pipe (18) to
connect deflector to the
outlet hole D of the hood.
In case the hood is to be used
in exhausting version, then the
deflector must not be
mounted and fit an exhausting
pipe (18) to connect outlet
hole D of the hood to the
outside.
• Make electrical
connection (13), but
leave the hood
disconnected from the
home general electric
panel.
• Fix the chimney (16a)
to the chimney support
(16b).
Slide down the lower section on
the proper housing on top of the hood.
Connect the hood the the home general electric
panel and check if the hood work properly.
40
Fig. 9