Atlantic Technology AW-5 Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Спікери Atlantic Technology AW-5. Atlantic Technology AW-5 8 сторінок.

Instruction Manual

Connecting Your Speakers

We recommend that you connect your speakers using high quality dual

conductor stranded wire of 16 gauge or heavier, for lengths up to 25 feet

(8m). Remember, the lower the gauge number, the heavier the wire. Use

heavier gauge wire for longer runs. Please contact your audio/video dealer

or installer for specific cable recommendations and further information

regarding special circumstances. The terminals themselves are designed to

allow the use of very heavy speaker wire or pin-type connectors.

WARNING: To prevent risk of electrical shock or damage to your

equipment, always switch off the amplifier or receiver when making

any system connections.

1. Remove ½-inch (13mm) of insulation from each wire end.

2. Twist the stranded wire together, keeping the two ends

separate.

3. Push down on the connector post and place the appropriate

wire through the postholes in the connector.

Be sure to connect red (+) on the speaker to

red (+) on the amplifier and black (–) on the

speaker to black (–) on the amplifier.

It's important to observe polarity while making speaker connections: red

(+) terminals on the amplifier to red (+) on the speaker, black (–) on the

amplifier to black (–) on the speaker. Look carefully at the wires you are

using and note that one of the conductors of each pair will typically be

identified by color, printing on the outer jacket, ridges on the outer jacket,

or a thread intertwined with the wire strands. By convention, the marked

wire is connected to the red (+) terminal.

WARNING: Before turning on the amplifier, be certain that no stray

wire strands are touching across any terminals as this might damage

your amplifier.

Finally, check the polarity of your front Left/Right speakers by listening to

some stereo music with good bass content. If the sound seems "hollow, "

unusually spread out, or seems to have weak bass, recheck your connections

for proper polarity and correct any out of phase connections by reversing

the connections to one speaker only, if necessary.

LEFT

RIGHT

Connecting