ADVANCED Network Devices IPSTROBE Інсталяції - Сторінка 6

Переглянути онлайн або завантажити pdf Інсталяції для Система безпеки ADVANCED Network Devices IPSTROBE. ADVANCED Network Devices IPSTROBE 6 сторінок.

Друкувати сторінку

Smart IP Strobe (IPSTROBE)

SNMP

SNMP set commands can turn the strobe on and off. In Device Settings → Network, set the SNMP

Write Community name for writing to the device from a MIB browser or other SNMP software. In the

SNMP software interface, access gpioOutputControl.1 (OID .1.3.6.1.4.1.39866.3.1.4.11.1.21.1), and

set to "1" to turn on the strobe, "0" to turn off the strobe.

You can also use SNMP to monitor the state of the strobe. In Device Settings → Peripherals, set GPIO

0 Output Transitions Send SNMP Trap to "Yes". On Device Settings → Network, add the IP address

and community name for a trap manager. The device will now send an SNMP trap to the configured

manager when the strobe goes on or off.

If using a configuration file (with

<GPIO

snmp_trap_for_output_gpio0="1"

<SNMP

write_community="nameTBD"

read_community="public" >

<TrapManager addr="10.10.3.4" port="162" pdu_version="2" community="nameTBD"

</SNMP>

WIRING REFERENCE

The unit is prewired, with terminal 1, "-", of the strobe connected to the relay "GND" on the board,

and terminal 2, "+" to "N.O." (normally open). We provide the connection details here for reference

in the event of any wires becoming dislodged.

Strobe Wiring Terminals

nameTBD

10.10.3.4

and

Advanced Network Devices • 3820 Ventura Dr. Arlington Hts. IL 60004

Support:

[email protected]

• 847-463-2237 •

provided only as example):

Board Connections

www.anetdsupport.com

v2.2