Bose AM267565 Посібник користувача - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник користувача для Спікери Bose AM267565. Bose AM267565 34 сторінки. Bose corporation user guide speaker am267565

Друкувати сторінку

Preparation

Figure 12

Running the cord up

through the attic

Figure 13

Running cord around a cor-

ner with nail plates for pro-

tection (a) and cutout

pieces as patches (b)

Getting started

Choose a path for the cord that avoids impediments to drill through. Use a stud ﬁnder to

identify inaccessible studs.

It is common to run cord from the speaker location in a wall or ceiling to the attic and through

the wooden top plate that runs horizontally across the top of the vertical studs. From the attic,

you can then run the cord to the spot above the junction box near the receiver or ampliﬁer.

Drill through the top plate at that point and route the cord through the hole and down into the

wall (Figure 12).

If you must route cord around a corner, you will need to cut out a rectangular piece of wall-

board on either side of the joist at that corner. Use each regular-shaped cutout as the patch

for the wall when you ﬁnish. By reaching through the cutout, you can notch the joist to make

room for the cord and use nail plates to cover the cord in each notch (Figure 13a).

To patch the wall, reposition the cutout pieces (Figure 13b) and use joint tape and joint com-

pound to hold them in place. When they are dry, sand and paint the area to match surround-

ing surfaces.

(a)

Nail plates

AM267565_01_V.pdf May 13, 2003

Top plate

Open-backed

junction box

(b)

Ceiling

Wall

Cutout pieces

Ceiling

Wall