Atlas Copco 4210 4480 70 Додаток до інструкції - Сторінка 3
Переглянути онлайн або завантажити pdf Додаток до інструкції для Інструменти Atlas Copco 4210 4480 70. Atlas Copco 4210 4480 70 8 сторінок. Reaction bar
Друкувати сторінку
Reaction bar
Instruction Supplement
Installing the reaction bar
1.
Attach the reaction bar to the tool and insert the retaining ring into the groove to hold the
reaction bar in place.
2.
Attach the socket to the square drive. Make sure to insert the locking pin through the
socket and square drive according to the illustration.
Operating the tool with reaction bar
1.
Attach the tool to the application.
2.
WARNING Be aware that the reaction bar will turn in the opposite direction to
the tool.
By using the reverse lever, the tool can be operated in both clockwise and counter-clock-
wise directions.
3.
Make sure the tool is placed in the correct position on the work surface as described in the
picture. The end surface of the reaction bar and the socket/nut must be aligned. Make sure
that the foot of the reaction bar hits the center of the nut that takes the reaction force.
4.
WARNING Never put your hand on or close to the reaction bar while the tool is
being used.
Press the push button to start the tool.
5.
Continue pressing the push button while running down the nut. With pneumatic tools you
can hear a sound, while the tool is running the nut down. When the sound decreases, re-
lease the push button to stop the tool. With electric tools the run down of the nut is con-
trolled by the Power Focus.
EN
© Atlas Copco Industrial Technique AB - 9839 0542 00
Instruction Supplement
3