advanced scale models DeHavilland DH88 Comet Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка advanced scale models DeHavilland DH88 Comet. advanced scale models DeHavilland DH88 Comet 8 сторінок.

Друкувати сторінку

STEP 12:

Before glueing the outer

wing panel to the centre

section, apply masking tape

around the edges of the

panels to be joined to help

prevent glue running on to

the covering. Join the panels with 30 minute epoxy. Remove the

masking tape from the panels before the epoxy has set. Use

rubbing alcohol or methylated spirits to remove any epoxy residue.

STEP 13:

Secure the ailerons in place

with a few drops of thin CA

adhesive applied to both

sides of the hinges.

Fit the control horns to the

ailerons and assemble the pushrods from the supplied parts.

STEP 14:

Install the elevator and

rudder servos in the

plywood servo tray in the

fuselage.

Adjust the length of the

elevator pushrod and the rudder pull/pull cables and fit to the

appropriate servo.

STEP 15:

The DH88 Comet is designed to

use either glow or electric power.

The supplied engine mounts are

used for both glow and electric

power.

STEP 16:

Fitting Glow Engines.

For glow engine power the

pre-assembled throttle servo

mounts need to be installed alongside the fuel tanks in each of the

engine nacelles.

_____ Page 5 _____

Elevator

Servo

Rudder

Servo