3M XT-1 Технічний бюлетень - Сторінка 3

Переглянути онлайн або завантажити pdf Технічний бюлетень для Гарнітури 3M XT-1. 3M XT-1 10 сторінок. Drive-thru systems
Також для 3M XT-1: Короткий довідник (6 сторінок), Короткий довідник (2 сторінок), Технічні дані (2 сторінок), Технічний бюлетень (2 сторінок), Посібник із швидкого старту (3 сторінок), Посібник (8 сторінок)

3M XT-1 Технічний бюлетень
Replacing the Inner Case Assembly, Outer Case Assembly, and Boom Microphone Assembly
Replacing the Inner Case Assembly
Tools Required:
1 - Small size Phillips screwdriver
1 - External retaining ring removal tool
3M OEM Parts and SKUs:
Procedure:
Important Note:
Be careful to avoid pinching wires between case halves when
reassembling the electronics case. Damaged wiring may cause the
headset to fail during use.
1. Make sure power is off and remove the battery from the headset as illustrated in Fig 3.
2. Remove the ear pad by using your fingers to pull the ear pad from the ear cup.
Then grasp the headset firmly in one hand, and pull the ear cup off the speaker
with the fingers of the other hand. See Fig 4.
3. To disassemble the electronics side of the headset begin by removing the three
screws shown in the illustration in Fig 5.
4. Carefully separate the inner and outer halves of the case assembly.
Support the Inner Case so the speaker cable is not strained.
Important Note:
It is important to disconnect the speaker from the main circuit
board as soon as the inner and outer case are separated to avoid
stress on the wires inside the sealed enclosure. Replace the entire
inner case assembly if the wires are broken at the speaker.
5. Remove the speaker wiring connector from the main circuit board. See Fig 6.
6. To install the new replacement Inner Case, connect the speaker wiring connector
on the speaker wires to the connector on the main circuit board.
7. Make sure the LED Lens is still in place. Otherwise, follow the procedure
Replacing the Indicator LED Lens to re-install the LED Lens.
8. Bring the two halves together and replace the screws as shown in Fig 5.
9. Reinstall the battery (Fig 7) and check operation of the headset prior to returning
it to regular operation.
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7
Speaker Wiring
Connector