Anova D1007 Інструкція з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Меблі для вулиці Anova D1007. Anova D1007 2 сторінки. 8' perforated metal picnic table, ada compliant, traditional edge, portable mount
Також для Anova D1007: Посібник із швидкого старту (3 сторінок)

Друкувати сторінку
Anova D1007 Інструкція з монтажу
4.
Position the remaining support near the other end of the tabletop.
Align the mounting holes in the support with the holes in the bracket on
the end of the tabletop. Install a washer onto a bolt and insert the bolt
through one of the mounting holes in both parts, with the bolt head on the
outside surface of the support.
5.
Locate the four rubber feet and place them in the outermost holes on the
bottom of the supports. Use the rubber mallet to set the feet into place.
6.
Locate one of the cross braces and position it so that the mounting hole in
one end aligns with the mounting hole in the bracket in the center of the
support. Put a washer on one of the bolts and insert the bolt through the
cross brace and support bracket and put a washer and nylock nut on the
end of the bolt.
Leave the hardware finger tight so that adjustments can be made while
assembling and leveling.
Position the other end of the cross brace so the mounting hole aligns with
the hole closest to the center of the tabletop bracket. Install a bolt and
washer through the cross brace and the tabletop bracket and install a
washer and nylock nut on the end of the bolt. Again, leave hardware finger
tight.
7.
Attach the other cross brace to the tabletop and other support bracket in
the same manner. Leave the hardware finger tight.
8.
Locate one of the seats and position it up to the support seat brackets.
Line up the mounting holes in the seat with the mounting holes in the
support seat bracket. Insert a bolt with a washer through each of the sets
of mounting holes and tighten finger tight.
Repeat this step for the seat on the other side of the table.
9.
Turn the table right side up and tighten all hardware while checking with a
level.
10.
Move the assembled table to desired location.
11.
Retighten hardware two weeks after initial assembly.
Note: Please contact Customer Care at 1-866-797-1761 when ordering replacement parts.
04/03/2018
Copyright 2018 ANOVA®
Washer and
Nylock Nut
Rubber
Foot
Bolt and
Washer
Cross Brace
Bolt and
Washer
Washer and
Nylock Nut
Made in USA.
Support
Bolt and
Washer
Tabletop
Rubber
Washer and
Foot
Nylock Nut
Support Seat
Bracket
2