AIRTRONICS SD-10G Aero Посібник з швидкого налаштування - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник з швидкого налаштування для Пульт дистанційного керування AIRTRONICS SD-10G Aero. AIRTRONICS SD-10G Aero 8 сторінок. 2.4ghz fhss-3 radio control system
Також для AIRTRONICS SD-10G Aero: Посібник (16 сторінок), Посібник із швидкого старту (5 сторінок)
Друкувати сторінку
section 1: UsinG tHe tYPe MenU, continUed....
Choose the desired Tail Type Option
Three Tail Type options are available - either Normal, V-Tail or 2xEL. Choose the option illustrated below that best matches
your aircraft's tail type. Choose Normal if your aircraft features a horizontal and vertical stabilizer and the elevator (whether
solid or split) is controlled by one servo. Choose V-Tail if your aircraft features a V-Tail and choose 2xEL if your aircraft features
a horizontal and vertical stabilizer and each elevator is controlled by its own individual servo.
This option can only be changed if you chose the WING>NORMAL option previously. If WING>DELTA is chosen, this option
cannot be changed.
TAIL>NORMAL
Horizontal and Vertical Stabilizer.
1 Servo Controls Solid Elevator
When V-Tail is chosen, the elevator and rudder channels are mixed together to
provide pitch and yaw control.
Choose the desired Throttle Type Option
Two Throttle Type options are available - either 1 or 2. Choose the option that best matches your aircraft's number of engines
or electric motors. Choose 1 if your aircraft features 1 engine or 1 electric motor. Choose 2 if your aircraft features 2 or more
engines or 2 or more electric motors.
Aircraft Features 1 Engine or 1 Motor
If your model features four engines or four electric motors, throttle control for both outer engines or motors should be Y-Harnessed
together and throttle control for both Inner engines or motors should be Y-Harnessed together, then THROTTLE>2 chosen. The
SD-10G does not support more than 2 throttle channels in AERO mode.
4) After making your Model Type selection choices, press the ENTER key.
The selection options will be displayed for verification. For example,
2A1F1E1R1T (2 Aileron servos, 1 Flap servo, 1 Elevator servo, 1 Rudder
servo, and 1 Throttle servo).
5) After verifying that the selection options are correct, press the YES/+ key to
Create New Data. After ~10 seconds, the new programming data will be
loaded into the transmitter as indicated by the progress bar.
4
Email: [email protected]
Horizontal and Vertical Stabilizer.
1 Servo Controls Split Elevator
THROTTLE>1
|
Website: www.airtronics.net
TAIL>NORMAL
THROTTLE>2
Aircraft Features 2 or More Engines or Motors
| Phone: (714) 963-0329
TAIL>2xEL
Horizontal and Vertical Stabilizer.
1 Servo Controls Each Elevator Half
TAIL>V-TAIL
1 Servo Controls Elevator and 1
Servo Controls Rudder