Auber Instruments DSPR300 Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Контролер Auber Instruments DSPR300. Auber Instruments DSPR300 12 сторінок.

Друкувати сторінку
AUBER INSTRUMENTS
Contactor
Heater for
acceleration
only
1
13
2
3
R
4
RTD
R
5
W
Figure 11. Wiring examples for auxiliary heater. Power supply is 120V AC. Coil
voltage to the contactor is 120V AC. Auxiliary heater and its contactor need to
be wired to AL1 relay output.
Example 3. Here is the wiring diagram of how to wire two external buzzers to
the controller.
N
120VAC
120VAC
buzzer
120VAC
L
1
13
14
6
2
7
3
8
R
4
9
RTD
R
5
10
W
Figure 12. Wiring example of external buzzers. Power supply for the controller
and heater is 240V AC. Power supply for two buzzers is 120V AC. AL1 buzzer
is for temperature alarm. AL2 buzzer is for timer alarm.
10. Common sensor errors:
This regulator will display error message or incorrect temperature reading if your
sensor is not connected, or your sensor is bad. Top display will flash "orAL" and
"932" alternately, if you set it to Fahrenheit display (C-F =
alternately, if you set it to Celsius display (C-F =
Auber Instruments
5755 North Point Parkway, Suite 99
Alpharetta, GA 30022
www.auberins.com
Email: [email protected] Tel: 770-569-8420
Copyright © 2021 Auber Instruments Inc. All rights reserved.
No part of this datasheet shall be copied, reproduced, or transmitted in any
way without the prior, written consent of Auber Instruments. Auber Instruments
retains the exclusive rights to all information included in this document.
2021.05
4
3
-
14
6
SSR
7
Heater
+
8
9
10
buzzer
4
3
-
SSR
Heater
+
F); or "orAL" and "500"
°
C).
°
N
120V AC
L
L1
240V AC
L2
WWW.AUBERINS.COM
P9/9