Airvent UV-C FiltAir 15 Інструкція з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Лабораторне обладнання Airvent UV-C FiltAir 15. Airvent UV-C FiltAir 15 16 сторінок.
Друкувати сторінку
Airvent UV-C FiltAir Instruction Manual
Fitting the Doors
Adjust the door to a height of approx 3 cm so that the hooks on the door are facing down. Then move the door down as far as it goes.
(The order is reversed as it was at dismantling.)
Attention!
Once the doors have been fitted, the safety screws must be screwed back on so that nobody can remove the doors while
the unit is running.
•
The device can only be connected to a 230 V power supply with protective earth.
•
The UV-C FiltAir unit belongs to contact protection class I., protection class IP20.
The 1,8 m power cable supplied as an accessory, must be installed without any risk of causing an accident, should be aesthetically
•
pleasing and should not constitute an obstacle during cleaning!
Installation and Use of UV-C FiltAir
1
Make sure the doors and safety screws are in place.
3
Connect the machine to the mains and turn on the power
switch located on the bottom of the machine next to the socket.
5
The airflow of the unit can be controlled with the potentiome-
ter on the front control panel.
It is advisable to keep the unit running on maximum airflow for an hour after turning it on and then to set the air volume based on the
number of people in the room.
10
2
Make sure that air can flow freely at the bottom and top of the
unit and that there are no objects on the top of the unit that
can obstruct the airflow.
4
The fan starts 10-20 seconds after the power has been turned on.
5
6
When set to maximum airflow, the unit can recirculate the air
of the room five times an hour, in accordance with the nominal
size of the unit.
UV-C FiltAir 45