Airwater Nordik Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Диспенсер для води Airwater Nordik. Airwater Nordik 11 сторінок.
Друкувати сторінку5.
Every Thermo Concept water cooler is thoroughly tested prior to
shipment from the factory. However, handling and transportation
between our factory and your home/office can cause a leak, thus
we recommend that you wait 2 minutes after placing the bottle
over the cooler. If you still see any air bubbles inside the bottle,
this is a sign that you may have a leak. If you witness a leak,
remove the bottle and go to the trouble shooting section.
6. If you think it was always handled vertically with care, then you
can connect it upon reception. If you have doubts about the way
the cooler was handled prior to delivery, wait at least one (1) hour
before connecting it.
7. Plug in the cooler.
CLEANING
THE COOLER
General aspects
Condenser:
In
order to ensure maximum performance of your water
cooler, you must remove any dust or dirt particles from the con-
denser. The condenser must be checked regularly and cleaned with
a vacuum cleaner (use a small round brush with long soft bristles).
Housing: Use a non-abrasive cloth with mild soap.
Drip tray:
To remove the drip tray, you need to pull it out horizontal-
ly on the Nordik and for the Pacific or Baltik, you need to lift it up.
Parts along the water flow
The cleaning
frequency depends on several factors such as:
* Local laws and regulations;
* Type of water used;
* Throughput (how much water flows through the coolers);
* Personal taste and preferences.
To ensure the quality of your drinking water, we recommend that
you clean the Nordik/Pacifik/Baltik cooler (parts that come into con-
tact with water) every 3 months, except the hot-water tank, which
we recommend once a year.
The cleaning methods can also
ing procedure.
vary but we recommend the follow-
5
a) Cook and Cold Model
1. Disconnect (unplug) the cooler;
2. Remove the bottle;
3. Drain the water from the reservoir by pressing on the taps of both
faucets until no more water flows out of the nozzles;
4. Remove the ring
on top of the cooler
by turning it counter-
clockwise;
5. Remove the "no-spill"
cone by strongly pul-
ling it upwards by the
tongue located on one
side of the cone.
6