3T-Components 3T-MOTORS 3T35-13 Посібник з монтажу та експлуатації - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Двигун 3T-Components 3T-MOTORS 3T35-13. 3T-Components 3T-MOTORS 3T35-13 20 сторінок. Shutter / awning motors with mechanical limit switches, for shafts from 60/40 mm
Друкувати сторінку
INSTALLATION INSTRUCTIONS
INSTALLATION AWNING MOTOR
Preparation:
1
Screw in awning & secure with straps or ropes.
•
Remove awning from wall bracket & place on safe surface.
•
Prepare motor for installation:
2
Slide limit switch adapter flush against motor head.
•
Secure the shaft adapter with the supplied securing bracket.
•
2.1
Motor head
Limit switch adapter
Installation awning motor:
3
Remove the cover to access the side bearing (also awning bracket)
•
and fastening screws.
>
fig. 3.1
Loosen the screw that secures the side bearing to the support tube.
•
Remove all screws connecting the side bearing
•
and the crank mechanism.
>
fig. 3.3
Remove the side bearing from the support tube.
•
Remove the crank mechanism.
•
3.1
Side bearing
Cover
Shaft &
3.5
wound up
Awning
Support tube
>
fig. 2.1 / 2.2
>
fig. 2.3 / 2.4
2.2
>
fig. 3.4
>
fig. 3.5
3.2
Side bearing
3.6
Shaft capsule
2.3
Securing bracket
Remove the shaft capsule from the shaft.
•
If the shaft capsule is tight, use a hammer and screwdriver.
Be careful not to damage the shaft.
>
fig. 3.2
Push the awning motor with shaft adapter first into the shaft.
•
Make sure motor head & limit switch adapter are flush in shaft.
•
Screw the universal bearing onto the side bearing on the side
•
facing the awning shaft.
Crank mechanism
3.2
Support tube
3.7
Attention:
Awning arms are under strong tension!
2.4
>
fig. 3.6
>
fig. 3.8
3.4
Shaft &
3.8
wound up
Awning
3T-MOTORS Tubular motors | Installation instructions
Shaft adapter
Click
>
fig. 3.7
Universal
bearing
14