Audiolab 8300A Інструкція користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція користувача для Підсилювач Audiolab 8300A. Audiolab 8300A 13 сторінок.
Також для Audiolab 8300A: Інструкція користувача (13 сторінок)

Друкувати сторінку

1. Operating Modes

4: Remote Handset

NOTE : the handset buttons shown crossed out are for use with other 8300CD

Audiolab units and are not operational when used with the 8300A

1 STANDBY

Press to bring the unit in/out of Standby

2 MENU

Press to enter menu mode

Move to next menu page or setting

4 VOL–

Press to decrease Volume

5 XLR

Press to select XLR input

6 PHONO

Press to select Phono input

7 VIDEO

Press to select Video input

8 TUNER

Press to select Tuner input

9 DISPLAY

Press to toggle the display on/off

Press and hold to select display brightness levels

10 MM/MC

Press to toggle Phono MM/MC mode

11 AUX2

Press to select Aux2 input

12 AUX1

Press to toggle different digital input

13 CD

Press to select CD input

Press to select menu page or setting

Move to last menu page or setting

16 MUTE

Press to mute and unmute the sound

Page 4

Fitting Batteries

Open the cover, unwrap the supplied AAA batteries and

place them in the battery compartment with the polarity as

shown, replace the cover.

Always use AAA batteries and always replace them in sets.

Never mix old and new batteries. Very weak batteries can

leak and damage the handset. Replace them in good time!

There is a risk of fire and burns if a battery is handled

improperly. Do not disassemble, crush, puncture, short

external contacts, or dispose of in fire or water.

Do not attempt to open or service a battery. Discard used

batteries in full accordance with recycling regulations in

force in your area.

Handset Operation

The handset operates several Audiolab components. The

handset buttons shown crossed out are for use with other

Audiolab units and are not operational when used with the

8300A.

Point the handset at the remote receiver and press the

relevant key. The handset should be within 15 meters of the

player and there must be a clear line of sight between the

two units.