AEV Bison Посібник з монтажу - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу для Лебідки AEV Bison. AEV Bison 12 сторінок.

Друкувати сторінку
2.
Disconnect the leads labeled A, F1, and F2 and remove the Warn harness from the controller (fig. 10).
3.
Route AEV harness through the AEV bracket and into the controller through the same openings the
Warn harness was removed from.
Connect AEV leads. Yellow = A, Green = F1, Blue = F2
4.
5.
Isolate the small black motor ground wire inside the controller. Cut and splice in the new motor ground
wire from the AEV harness. NOTE: Make sure the splice will be located within the winch controller
enclosure when reassembled.
6.
Mount the controller to the bracket using QTY 2 flange nuts provided. (fig. 11).
7.
Reinstall QTY 4 bolts to reassemble controller housing.
A M E R I C A N
E X P E D I T I O N
A
F2
F1
Figure 10
Figure 11
V E H I C L E S
4