Audiotec Fischer PP 62DSP Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Audiotec Fischer PP 62DSP. Audiotec Fischer PP 62DSP 16 сторінок. Extension card
Також для Audiotec Fischer PP 62DSP: Інструкція з монтажу (2 сторінок)
Друкувати сторінку
Connectors and control units
Subwoofer Output
1
Connector for a passive MATCH PP
subwoofer.
Input Sensitivity
2
Control for adjusting the input sensitivity of
the highlevel inputs.
5
USB Input (slave only)
5
Connects the PP 62DSP to your PC.
Control pushbutton
6
Use this button to either switch between the
setups or initiate a reset of the device.
Status LED
7
This LED indicates the operating mode of the
MicroSD card reader
8
setups to the PP 62DSP.
Rem In / Out
9
The remote input can be used to switch on
the PP 62DSP. The remote output has to be
connected to the RCA Line Output.
16
1
2 3
6
7
8
4
Clipping LED
3
This LED lights up red if one of the analog
inputs is overdriven.
System Connector
4
Connector for the MATCH cable harness.
Make sure that you only use the original ca-
the PP 62DSP with your car radio.
9
10
11
12
RC Switch Aux / Byp
10
This switch determines the functionality of
the "MODE switch" of an optional available
URC remote control.
Control Input
11
Multifunction interface for e.g. an optional
remote control or other MATCH PP 62DSP
accessory.
RC Control On / Off
12
Use this control to activate resp. deactivate
the functionality of a remote control.
Line Output
13
(Rem Out) is used to turn on these devices.
13
-