Audiotec Fischer PP 62DSP Посібник користувача - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач Audiotec Fischer PP 62DSP. Audiotec Fischer PP 62DSP 16 сторінок. Extension card
Також для Audiotec Fischer PP 62DSP: Інструкція з монтажу (2 сторінок)
Друкувати сторінку
Installation
The Input Sensitivity potentiometer (item 2 page 17)
is used to adapt the input sensitivity to the output
voltage of the connected head unit/car radio. This
control is no volume control and is only for adapting
the input sensitivity. Adjustments with this poten-
tiometer only affect the highlevel inputs!
deliver enough output level, the input sensitivity
should be increased by turning the rotary potenti-
are used the Clipping LED has no function.
In this case the right setting has to be found by ear
and adjusted that way that no distortion is audible.
In combination with the DSP PC-Tool software the
Clipping LED is an indicator for overmodulation.
Please make sure that you choose an appropriate
sensitivity setting that the LED never lights up.
Caution:
output than the car radio itself. Most of the OE
speakers in the car will be able to handle this
extra power easily. Nevertheless, please take
care when you crank up the input sensitivity. If
you hear strong distortion, please reduce the
volume to an appropriate level in order to avoid
damaging your speakers.
Note - Cars equipped with MOST bus:
In cars equipped with MOST bus structure it is
the original car radio connector and insert it into
the car radio connector of the MATCH cable har-
ness which has a dedicated recess for this.
22
The PP 62DSP will be turned on automatically if the
highlevel inputs are used or if a signal is applied
to the Rem In terminal. The "Automatic Remote"
switch allows to deactivate the automatic turn-on
feature.
The feature should be deactivated if there are e.g.
disturbing noises while switching on/off the ampli-
-
Note: If the automatic turn-on function is deactivat-
ed it is mandatory to use the Rem In terminal to
ignored in this case.
Note:
To deactivate the automatic turn-on feature you
have to open the device and change the position of
the "Automatic Remote" switch.
Therefore dismantle the side panel (where the USB
input is located) by removing the Phillips screws.
Now you can pull out the bottom plate and get ac-
cess to the switch. The switch is located near by
following picture).
MEC slot
Position 1:
Activation via speaker input is enabled
Position 2:
Activation via speaker input is dis-
abled.
-