Abus PLBW10100 Посібник - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник для Датчики безпеки Abus PLBW10100. Abus PLBW10100 18 сторінок. Nexello motion detector
Також для Abus PLBW10100: Короткий посібник (2 сторінок)

Друкувати сторінку

2.2. Planning, assembly and installation

The device uses low-power radio signals to communicate with the Z-Wave controller. For best results,

please note the following:



Please do not attach directly to metal planes or metal constructions, as this may limit the range.



The device has a radio range of up to 40 m indoors.



The battery life of the device is reduced if the wireless connection to the Z-Wave controller is not

direct but via a repeater.

Test mode

Press the tamper switch 3 times in 1.5 seconds to activate the test mode. The LED lights up for 2

seconds to confirm. The test mode switches off automatically after 10 minutes.

In test mode



the preset waiting time is ignored and set to 5 seconds.



each motion alarm is acknowledged after 5 seconds, but to send a new motion alarm, the

motion detector must not have detected any motion for 5 seconds.

Use the test mode to select the optimal installation location.

Select installation location

The detector is only suitable for indoor installation.

When selecting a position for the detector, the following points should be observed:



Do not install the detector opposite a window or where it is exposed to direct sunlight. PIR

detectors are not suitable for use in conservatories due to the high temperature fluctuations.



Do not install the detector where it is exposed to fans or air conditioning.



Do not install the detector near a heat source (e.g. fire, radiator, boiler, etc.).



Do not mount the detector in a position where it is subject to excessive vibration.

Assembly instructions:

Sensitive

Insensitive

The successful inclusion is displayed in the app or on

the Z-Wave controller and the status LED on the

device

lights

Repeat the inclusion process if it was not successful.

If a new attempt fails as well, first carry out a factory

reset on the device, see 2.5.

The detector is designed for mounting on a flat wall or

in a corner.

If possible, mount the detector in the corner of the

room so that the path of a person passes through the

detection

zone.

PIR

effectively to movement through the detection zone

than to movement towards the sensor.

English

red

for

seconds.

detectors

respond