Audiovox 1181279 Інструкція з монтажу Посібник з монтажу - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Автомобільна відеосистема Audiovox 1181279. Audiovox 1181279 6 сторінок. Overhead console for use with flipdown video system chevrolet venture

Друкувати сторінку

9. Install jumper wire harness (item 10 pg 2) to

extend the O.E.M. audio control harness, if

equipped. See Figure 6.

IF VEHICLE IS NOT EQUIPPED WITH FACTORY REAR A/C AND REAR AUDIO CONTROLS,

FIGURE 7

12. Install A/C switch on driver's side opening and audio

controls on passenger's side opening. Note: Make sure

switches and controls are installed in the proper

direction. Remove backing from tape on switch mounting

brackets (item 8 pg 2) and install (1) one bracket on top

and (1) one on bottom of each switch. Press firmly on

brackets to secure to switch and inside of console.

FIGURE 5

II. PREPARATION OF CONSOLE FOR INSTALLATION

PROCEED TO STEP 13.

7. Remove and retain (2) two screws which secure front

mounting bracket (item 6 pg. 2) to console (item 11 pg

2). Install front mounting bracket over O.E. brace,

align slot with center line scribe and front edge of the

O.E. brace. Make sure that the bracket is centered

left to right. If applicable align and fasten O.E. screws

in O.E. clips in the roof of the vehicle. Secure using

(4) four # 10 x1/2" screws (item 1 pg. 2). See Fig. 5.

8. Inset rear mounting bracket (item 7 pg. 2), with bent

edges upward, between headliner and sheet metal roof.

Slide bracket rearward until tabs engage rear O.E.

brace. Make sure that bracket engages securely.

Align slots in bracket with the center line scribed in the

roof. Secure brackets together using (3) three

10 x1/2" screws (item 1 pg. 2). See Figure 5.

10. Carefully remove cover from respective switch

location on console (item 11 pg 2) if applicable.

See Fig. 7.

11. Using a razor knife, trim away tab.

FIGURE 6

FIGURE 8