Apogee V-2 Conversion Kit Інструкція - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція для Іграшка Apogee V-2 Conversion Kit. Apogee V-2 Conversion Kit 5 сторінок. Converts the spacemonkey models v-2/a4 plastic model kit into a flying model rocket
Друкувати сторінкуinsert the motor mount tube into the aft end
of the body tube SO THE BACK RING IS
RECESSED AT LEAST ¼ INCH (6.5mm)
INSIDE THE END OF THE TUBE. Also,
the engine hook should NOT be in line with
the line on the tube. When the glue is dry,
pass the shock cord back through the motor
mount, so that it comes out the front end of
the rocket.
Step 6 - Take the red tube coupler and
place it on the plastic "aft nozzle insert" from
the Spacemonkey Models V-2 kit. Do not
glue it. Make sure it is straight on the nozzle
insert. Draw a line on the plastic with a pen-
cil, and remove the coupler tube.
Step 7 - Using a razor saw, cut the top
off the nozzle insert using the pencil line as
a guide. Clean up the edge with sandpaper.
The domed portion can be discarded.
Step 8 - Mark the middle of the aft edge
of the nozzle insert on the recessed portion
as shown. Anywhere around the ring is fine,
but this will now be the centerline of the fin.
Step 9 - Test fit the nozzle insert into the
back of the body tube from Step 5. The line
you made in Step 8 should align with the
pre-marked line on the outside of the body
tube. Also make sure the tube is straight on
the nozzle insert, and then glue it into place
using thick super glue.
Step 10 - Locate the laser-cut cardstock
centering ring. The side with the line etched
on it is the front side. Slide the ring over
the body tube and onto the front end of the
tube. The line on the ring should be aligned
with the lengthwise etched line of the tube,
and the front edge of the ring should be just
behind the perimeter line. Do not glue it yet.
Step 11 - This is a critical step, so be
sure to understand what has to occur before
you glue things into place. Slide the tube
into the rear of the blow-molded tube from
the plastic model kit. Refer to Step 7 of the
instruction sheet that came with the Space-
monkey Models V-2/A4 kit in how the nozzle
insert is aligned with the fin location of the
blow molded tube. Looking from the front
side of the blow molded tube, check to see
if the paper centering ring is making good
contact with the inside edge of the blow
mold tube. When you are sure you under-
stand how everything fits together, remove
the parts and glue them together using thick
super glue.
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
Page 3