Apollo Enclosures AE7570 Посібник з монтажу - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник з монтажу для Корпус Apollo Enclosures AE7570. Apollo Enclosures AE7570 16 сторінок. Environmental tv enclosures (with tv swing brackets) mastering the outdoor tv viewing experience from the inside out
Друкувати сторінку
5. Attaching the Back Panel to the Mount
NOTE:
Be sure your mount is completely installed to your outside location and all cables
are run before proceeding.
a. Attach back panel to wall mount, lock the mount in the desired tilt or non-tilt position and tighten tilt
adjustment screws before hanging TV. Refer to directions included with your mount.
b. Run 9' enclosure power cord through rectangular hole in back panel and plug into a GFCI
receptacle with an outdoor rated "in use" cover plate. (See safety statement)
c. Run your signal cable(s) from outside through rectangle opening in rear panel to be hooked up in
next step.
6. Installing the TV to the Back Panel
a. Lift TV and align swing bolts (located on top of TV hanger brackets) above hanger hooks on top of
rear panel and carefully lower into place.
b. Check side to side alignment to be sure TV is centered left to right.
c. Swing bottom of TV outward; plug TV into 3 outlet A/C power receptacle on rear panel and make
appropriate signal connections.
d. To lock TV in place, pull latch cord down, push TV toward bracket and release. Be sure all cables
are clear from interfering with TV swing brackets.
e. Test operation of TV.
IG1902 43-86 Swing A
Copyright 2019 Apollo Enclosures LLC. All rights reserved
f.
Attach cable cover, securely tighten into threaded inserts, and
neatly dress all cables using wire cable management covers on
mounts, and wire ties, as necessary.
NOTE: For best results, position cables flat against rear panel.
Page 13