Addvent AVAC12000 Інструкція з монтажу та посібник користувача - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник користувача для Кондиціонер Addvent AVAC12000. Addvent AVAC12000 20 сторінок.

Drainage

When the unit is operating in Cooling or Dehumidify ( DRY) mode, humidity

extracted from the air is collected in an internal tank. If the tank reaches full, the

compressor and motor cut out automatically. At the same time, the "Water Full"

indicator comes on. An alarm will also sound. When the tank is full, carry out the

following instructions:

1. Turn off the air conditioner and avoid moving

it when full.

2. Position a container (a water tray for

example) underneath the drain hole.

3. Remove the drain knob & rubber plug from

the drain hole and allow the water to drain

out.

4. When the container is almost full, replace the

rubber plug in the drain hole and empty the

water tray.

5. Repeat until the unit is emptied.

6. Replace the rubber plug and tighten the drain

knob firmly.

7. Switch on the unit - the full water or

compressor operating indicator should not be

flashing.

Should you prefer to use the appliance without

having to empty the tank every so often,

proceed as follows :

Remove the drain knob and rubber plug and

retain for future use.

Connect the drain tube supplied to the

water outlet as shown and locate the other

end into a drain.

The drain tube may be extended by adding

an extension tube and using a suitable

connector.

FIG 17

FIG 18

FIG 19

FIG 20