Addvent AVH23 Інструкція з монтажу та посібник користувача - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник користувача для Сушарка Addvent AVH23. Addvent AVH23 2 сторінки.
Друкувати сторінку
AVH23[16]instructions
26/2/16
10:30
Safety Instructions
Important Safety Information – Please Read before
Proceeding
The information contained in these installation
G
instructions must be read carefully before any attempt to
install the hand dryer.
This appliance is not intended for use by persons
G
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Failure to accurately follow these instructions may result
G
in the incorrect operation of the unit, damage to property
and/or personal injury.
Addvent will not be held liable for any damage to
G
property or personal injury as a result of failure to comply
with the instructions contained herein.
All electrical installation and repair work should be carried
G
out by a qualified electrician in accordance with current
UK IEE regulations and any local codes or regulations.
Any maintenance to this appliance should be carried out
G
by a qualified electrician.
This product must be earthed.
G
Isolate power to the device before installation or
G
servicing.
Check that the electrical supply corresponds to that
G
shown on the rating plate on the device.
NOT to be used for any purpose other than drying hands.
G
Page 2
WARNING
2
Installation
Before installation
G
Be sure to select a suitable position to
install the hand dryer – figure 1.
G
Make certain that you have all the parts
and appropriate tools for installation.
G
Ensure that the power is disconnected
before installation.
Installation
Electrical
G
The electrical supply required for this unit is
(single phase) 220V AC, 50Hz.
NOTE: a circuit breaker (RCCB) may be
required in certain installations.
Installation
G
Firstly, remove the outer casing by undoing
the two screws in the bottom of the
casing– see figure 1. Then detach the
connecting cable – see figure 2
G
Using figure 3 as a guide, offer up the
backplate in the preferred mounting
position and mark the position for the 4
holes.
Drill the holes and affix wall plugs.
G
Mount the backplate and fix screws,
making sure to pull the power cable
through its hole in the backplate – see
figure 4
G
Ensure the backplate is secure, reconnect
the connecting cable, and then replace the
outer casing and fix the screws on the
bottom surface.
3
AVH23
FIG 1
FIG 2
FIG 3
FIG 4