AUSTRALIAN MADE GREAT MATE Інструкції зі встановлення та налаштування - Сторінка 6

Переглянути онлайн або завантажити pdf Інструкції зі встановлення та налаштування для Двигун AUSTRALIAN MADE GREAT MATE. AUSTRALIAN MADE GREAT MATE 20 сторінок. Double swing gate motor kit

Друкувати сторінку

THE BATTERY BEFORE MAKING ANY WIRING CONNECTIONS

We recommend the gate motor settings and direction of rotation be set up and tested prior to

installation. Place the gate motors on a suitable work bench.

Care should be taken as there are moving components inside the gate

motor that may cause damage or personal injury.

Slave Motor

Determine which side of the gates to mount the MASTER motor to (the gate motor with the

circuit board and battery). Typically, the master motor is located on the side of incoming power.

Some double gates require a time delay in opening / closing to prevent the two gates clashing.

Determine which gate will need to open first & therefore close last. Typically, one or other of the

gates may be fitted with a 'lip' or 'tab' to help align the gates when closed. The lip or tab may be

fitted to the leading edge of the first-closing gate or the trailing edge of the last-closing gate.

The motor (master motor or slave motor) of the first opening gate / last closing gate must be

connected to Motor M1 terminal. (See above)

Pre Installation Set Up and

Testing

Double Swing Gate

Motor Set Up and Bench Testing

ALWAYS TURN THE POWER OFF AND DISCONNECT

Master Motor

Battery

Motor

Wires

Motor M2

Terminals

Battery

Wires

Motor M1

Terminals (First

Opening Gate /

Last Closing

Gate)