Auta DECOR AUTA KEY Посібник - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник для IP-контролери доступу Auta DECOR AUTA KEY. Auta DECOR AUTA KEY 8 сторінок.

Друкувати сторінку

DECOR AUTA KEY

auta

INTRODUCTION

Decor Auta key is an access control that can be installed either individually or integrated in a door & video door Auta panel.

The codified access control lets till 300 different codes. The user could choose between codes of 5 digits.

The system lets either release the door opener from inside using an auxiliary push-button or detect (if a door sensor & alarm is

installed) whether the access is incorrectly done or forced.

FUNCIONING

To release the door opener an authorised code must be typed. The code from factory is

If a wrong code is typed the full operation must be repeated. After 15 wrong codes a warning tone will start during 20 seconds.

If the equipment has been installed with door sensor with alarm & opening push-button, we should release the door opener using the

key or pressing the internal push-button to avoid the alarm.

To authorise or cancel codes is necessary to type a password to enter the programming mode.

PROGRAMMING MODE

To enter the programming mode, the following sequence must be typed:

C 8 7 7 7 7

coming up 6 short tones will sound. This code comes from factory.

•

Change the access code to the programming mode (recommended).

C 1 1 C X X X X X

Some tones will sound each 5 seconds while the auta key is in programming mode.

•

CODIFICATION

All the codes should have the same number of digits.

For codes with 5 digits:

C 0 6 C X X X X X

•CODES CANCELLATION

To cancel an access code, we should introduce the following sequence:

C 0 7 C X X X X X

•

CANCEL ALL THE CODES

WARNING: This function delete ALL the access codes and restores the factory code

C 2 7 C

If the confirmation sequence has been correctly made, then 2 large confirmation tones will sound, if not 1 large mistake tone will

sound.

To cancel a sequence of commands (before type

Once the programming mode finished, type

After 50 seconds spent without type any key, the Auta Key returns back to its normal functioning status.

ALARM

This function activates an alarm in case of a non authorized access opening.

20 second warning tone is emitted when the the alarm is activated, the output contact "Relay 2" is closed. (See schema pag.3)

A device type "open contact" must be used to detect the access opening.

Type a valid access code or press the auxiliary button of the electrical strike to unable the alarm.

where XXXXX is the new code to get into the programming mode.

authorise a code XXXXX of 5 digits.

cancel a code XXXXX of 5 digits.

) type

1 2 3 4 5

2 times.

1 1 1 1 1 1 1 1 1

functioning and codification