Gage Bilt GB740 Оригінальна інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Оригінальна інструкція з експлуатації для Заклепочні інструменти Gage Bilt GB740. Gage Bilt GB740 20 сторінок.
Також для Gage Bilt GB740: Посібник з монтажу (12 сторінок)
Друкувати сторінку
WARNING:
Any other use is forbidden.
The GB740 is a pneumatic-hydraulic installation tool designed specifically for the efficient installation of blind rivets. It weighs 6.50 lbs.
(2.95 kg) and can be operated in any position. It has a 1.330" (33.78 mm) fastener setting stroke and a rated pull load of 2,400 lbs. (10.7 kN)
with 90 psi (6.2 bar) of air pressure at the air inlet.
The GB740 installation tool operates on 90 to 100 psi. (6.2-6.9 bar) of air pressure, with 90 psi. (6.2 bar) providing the maximum efficiency.
At 90 psi. (6.2 bar), the GB740 does not exceed 81.5 dB(A) and consumes .30 SCF/cycle (8.50 L/cycle).
The air inlet is provided with 1/4-18 female pipe thread to accept the users air hose fitting.
NOSE ASSEMBLIES ARE NOT FURNISHED WITH THIS INSTALLATION TOOL AND MUST BE ORDERED SEPARATELY. (See nose
assembly selection chart on page 18 for nose assembly recommendations).
WARNING:
Do not operate in an explosive atmosphere.
The GB740 can be operated between 0ºF - 118ºF (-17.8ºC/47.8ºC)
GB740 S/N 1175 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
DESCRIPTION
ENVIRONMENTAL USE
SPECIFICATIONS
Hand Held Weight
- 6.50 lbs. (2.95 kg)
Air pressure req'd
- 90-100 p.s.i. (6.2-6.9 bar)
Air consumption
- .30 SCF/cycle (8.50 L/cycle)
Hydraulic oil
- Automatic Transmission Oil,
Setting stroke
- 1.330" (33.78mm)
Noise level
- less than 81.5 dB(A)
Rated pull load
- 2,400 lbs. (10.7 kN)
Vibration
- Tested– No hazards found.
Dexron® III, or equivalent.
4
Rev. 5/22