GREAT PLANES Gee Bee Інструкція з експлуатації - Сторінка 10
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES Gee Bee. GREAT PLANES Gee Bee 16 сторінок. Model aircraft great planes gee bee
Друкувати сторінку
❏ ❏
6. Pull the elastic thread through the fuselage. Pass the
thread through the fl ying wire retainer as shown.
❏ ❏
7. Follow the same procedure to install the aft fl ying wire.
❏ ❏
8. Adjust the tension on the fl ying wires so that there
is no slack in the elastic thread. But, they need to be able to
stretch if hit.
❏ ❏
9. Position the spreader bars so that the fl ying wires are
straight. Apply a drop of CA on the joint between the spreader
bars and the fl ying wires to hold the spreader bars in place.
❏
10. Return to step 1 and install the fl ying wires through
the left wing.
❏
11. Pass the elastic thread through the two holes in the
belly pan and through the hole in one of the inside wheel pants.
❏
12. Glue the elastic thread to the wheel pant as before.
❏
13. Cut the elastic thread a little long at the other wheel
pant. Pass the thread through the wheel pant so that a slight
amount of tension is on the thread. Apply a drop of CA to the
thread. After the CA has hardened, trim the thread fl ush with
the inside of the wheel pant.
BALANCE THE MODEL (C.G.)
CAUTION: Disconnect the motor battery and switch the
transmitter off.
❏
1. Slide the aluminum collet type prop adapter on the
motor shaft.
10