ADEMCO TI110B1 Посібник користувача - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник користувача для Система безпеки ADEMCO TI110B1. ADEMCO TI110B1 18 сторінок. Gsm/pstn dual network burglar alarm system

Друкувати сторінку
Either the telephone or the local line is
put
in the wrong position
Telephone fails
to dial the
The numbers you store are wrong or are
numbers
not stored successfully
There
telecommunication line
Battery runs out
Detector is not activated or the alarm is
PIR
detector
not armed
doesn't work or is
The detector is in the "USE" mode, and
slow in detecting
there is a interval of 1 minute before
the target
restart detecting
The
successfully
Repeat false alarm
after
months
of
The battery runs short
working
The "Under-voltage" indicator shines and
the battery runs out
Alarm failure when
The distance between the magnetic panel
the
indicator
of
and the transmitter is too far
magnetic
contact
still shines
The code has not matched successfully
The remote control
Some key get lock (the indicator shines)
doesn't work
The battery runs out
No
alarm
sound
The alarm panel is set into "Mute"
when alarming
Immediate alarm on
The short-circuit wires of "Zone 2" and
arming
"Zone 10"get loose or fall off
The alarm panel
The zone has matched code with 3
doesn't sound voice
detector or the alarm panel has matched
indicator
when
with 15 different remote controls
automatic
code
The code of detector is the same as that of
with
one matched code of another detector
detector/remote
control
is
something
wrong
code
has
not
been
18
Put
the
local
telephone line into the right
positions
Re-store the right numbers
with
Eliminate the fault of the local
line
Change a new battery
Activate the detector and arm
the alarm panel
Change the working mode into
"Test" mode to have a test
matched
Rematch the code of detector
Change a new battery
Change a new battery
Make
sure
between the transmitter and
magnetic panel is within 1cm
Rematch the code of magnetic
contact
Reset the lock key
Change a new battery
Set the alarm volume into
"High-volume"
Make sure the short-circuit
wires fixed well
If necessary, please clear all
matched codes of this zone
Clear the matched code or
change the 8-address code of
detector for different code
line
and
the
distance