GREAT PLANES XPD-8 Інструкція з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES XPD-8. GREAT PLANES XPD-8 16 сторінок.

❏

2. Drill a 3/8" [9.5mm] hole in the forward inside corner of

each servo bay for the servo leads to pass through. The holes

should be approximately 1-1/2" [38mm] deep and at an angle

of about 20° in relation to the underside of the wing. Finish the

holes for the servo leads by cutting downward at the marks you

made from the top side of the duct channel top. Make sure

these holes are close to the center of the duct channel top as

shown but not entering the duct channel.

❏

3. Cut off three arms from the four-arm servo horns

included with the servo and enlarge the outer hole with a

3/64" [1.2mm] drill bit. Center the elevon servos with your

radio system and install the arms at a right angle to the

servo case as shown. Cut the mounting tabs from the servos

and feed the servo leads through the holes you made.

❏

4. Glue the elevon servos into the servo bays.

❏

5. Use a straightedge in line with the servo horns to mark

the locations for the elevon control horns.