ADEMCO LYNX Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Датчики безпеки ADEMCO LYNX. ADEMCO LYNX 17 сторінок.
Також для ADEMCO LYNX: Посібник із швидкого старту (8 сторінок), Посібник користувача системи (14 сторінок)

Друкувати сторінку

*81 ZONE LISTS

Use this mode to define zone lists for Powerline Carrier Devices and/or for the chime by zone feature. Press *81

while in programming mode. NOTE: Entry of a number other than one specified will give unpredictable results.

ZONE LIST PROGRAMMING

0 = Exit mode, upon which this prompt blinks. Press [*] + any field number to go to that field.

1 = Enter mode

ZONE LIST NUMBER

Enter the 2-digit zone list number (01-03) to be programmed (use zone list 03 for chime by zone feature).

[*] = Continue

00 = Exit mode (displays blinking 81; enter * + desired data field or menu mode number)

ZONE ENTRY TO LIST

Enter the 2-digit zone number ( zz ) to be added to this zone list.

[*] = Accept zone number and enter the next zone number

00 = Accept zone number and continue to next prompt

DELETE ENTIRE ZONE LIST?

0 = Don't delete; continue to next prompt

1 = Delete the current zone list

DELETE SPECIFIC ZONES FROM LIST?

0 = Don't delete; continue to next zone list number (prompt A 01)

1 = Continue to delete zones prompt

DELETE ZONES

Enter the 2-digit zone number to be deleted from the current zone list

[*] = Delete zone and enter next zone to be deleted

00 = Return to next zone list number (prompt A 01)

*83 SEQUENTIAL MODE

Use this mode to enter transmitter serial numbers. Press *83 while in programmng mode. NOTE: Entry of a

number other than one specified will give unpredictable results.

ZONE NUMBER

Enter the 2-digit zone number of the first transmitter to have its serial number entered.

[*] = Continue; system searches for zones not yet entered, then goes to ENROLL SERIAL NUMBER

prompt (C)

00 = Exit Sequential mode, upon which the prompt "83" blinks. Press [*] + any field number to go to that

field.

ENROLL SERIAL NUMBER

Enter the transmitter's 7-digit serial number (printed on the transmitter). If you enter an incorrect digit,

press the [#] key to backup to that digit and reenter the correct digit.

When all 7 digits are entered, press the [*] key. Each digit will be re-displayed, and the keypad will beep

once for digits 1-6, 3 times for the last digit. If less than 7 digits are entered, the un-entered digits will

display "F." If too many digits have been entered, the first 6 digits will be saved, along with the last digit

that was entered (entering 123456789 yields serial number 1234569).

If the serial number is correct, press [*] again to save it. The next zone number to be enrolled will display

at "C" prompt for 30 seconds. If this is the desired zone number, enter its serial number as described

above. If not, either wait 30 seconds or press [#] to display "b" prompt.

If the serial number is not correct, press [#], which deletes the number and returns to the ENROLL ZONE

prompt (b), allowing you to reenter the number.

ENROLL ZONE?

The system displays the next zone number for which a serial number may be enrolled.

0 = return to ZONE NUMBER prompt (A 01) to enter different zone number or exit sequential mode

1 = yes, return to "C" prompt to enter serial number for this zone

10 –

–