ADEMCO 5707 Інструкція з монтажу Посібник з монтажу - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Димова сигналізація ADEMCO 5707. ADEMCO 5707 12 сторінок. Smoke detector with built-in wireless transmitter
Друкувати сторінку
3.
to observe
correct
polarity,
and do not force
the
batteries
into the
compartment.
The LED indicator
should
flash
once
every 7 seconds,
indicating normal operation.
Note: if
the batteries are not installed corre~ly,
the smoke detector will not
function.
Install the smoke detector back onto the mountina
bracket, as indicated
in
step 3 of Detector Mounting Procedure on a pr~vious
page, and test
its
operation as described in TESTING THE SMOKE DETECTOR.
SPECIFICATIONS
Power source:
Two Duracell MN 1604 9-volt alkaline batteries
Sensitivity
to smoke:
3.1 %'ft * 0.5%At (30.4cm), nominal
Operating
Temp:
Tested 32°F–1200F
(O°C to 500C). Not for use where
normal ambient temperatures
are outside the range of
400F-100"F
(5°C-380C)
Humidity:
Oto 85% RH
Horn Loudness:
85 dB @ 10 feet (3m)
Reset:
Automatic
Test:
Push-to-test
button simuiates
gray smoke density of
not greater than 6'XOAt (30.4cm).
Power/Alarm LED:
Standby=
Flashing
Alarm = Steady
Radioactivity:
Contains NO radioactivity
Low Battery
Signal:
One horn beep every 15 seconds. Nominal for not less
than 7 days
Size:
6.1 inch dia, 1.84 inch high (15.5 cm dia., 4.6cm high)
Weight:
10.1 oz. (289 grams) with
two
batteries
NFPA
RECOMMENDATIONS
REGARDING
SMOKE
DETECTOR
INSTALLATION
I
For your information,
the National
Fire Prote~ion
Association's
Standard
74,
Section 204 reads as foilows: "2-4.1.1; Smoke detectors shail be installed outside
of each separate sleeping area and in the immediate vicinity of the bedrooms and
on each additional
story of the family
living unit including
basements
and
exciuding craw! spaces and unfinished attics. The provisions of 2-4.1.1 represent
the minimum number of detectors required by this standard. It is recommended
that the householder
consider the use of additional smoke or heat detectors for
increased
protection
for those
areas separated
by a door from the areas
protected
by the
required
smoke
detectors
under
2-4.1.1
above.
The
recommended
additional
areas are: living room, dining
room, bedrooms(s),
kitchen,
attic (finished
or unfinished),
furnace
room, utility room, basement,
integral or attached
garage,
and hallways
not covered
under 2-4.1.1
above.
However, the use of additiinat
detectors remains the option of the householder."
This equipment
should be installed in accordance
whh this standard (National
Fire Protection
Association,
Batterymarch
Park, Quincy, MA 02269). State and
iocai codes and ordinances
may ~nfticf
with the a&rve standard. We suggest
YOU
contact
your local fire authority
for local requirements
regarding
smoke
-6-