Automotive ET3334 Інструкція з експлуатації - Сторінка 4
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для GPS Automotive ET3334. Automotive ET3334 4 сторінки. Circuit tracer
Automotive Circuit Tracer
4.11 Tracing multiple loads:
When tracing a wire with multiple loads (refer Fig. E), it is better to disconnect all the other
unneeded loads. This is because the signal from the transmitter will flow along the whole
circuit and there may be too many loads, based on the circuit layout and loading circuit, this may
reducethe the signal strength and make it harder for the receiver to pick up the signal. The less
being traced, the easier it will be to get an accurate result.
4.12 When to change the battery:
Both red and green LEDs will flash and then power off automatically if the battery is low.
5. MAINTENANCE:
WARING! DO NOT attempt to repair or service this tool unless you are qualified to do
so. To avoid damage do not get water inside the case.
1. Periodically wipe the case with a damp cloth and mild detergent. Do not use solvents.
2. Turn the sender and receiver units off when not in use and remove the batteries if stored
for an extended period of time.
3. Do not store in a place of high humidity or high temperature.
4. To replace the batteries on either the sender or the receiver units, simply open the rear
battery cover and replace with a 9V battery.
Fig. E
-04-
2202AC