Hifonics ZRX111P Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Сабвуфер Hifonics ZRX111P. Hifonics ZRX111P 8 сторінок.

SAFETY INSTRUCTIONS

Ensure that your subwoofer enclosure will not get loose during the drive and hurt someone in the pas-

senger cabin. It is recommended, that you mount the subwoofer enclosure with suitable belts or any

other mounting solutions in the trunk area. Please ensure not to damage any serial components of your

vehicle (air bags, wires, gas tank etc.) during the installation of your sound system by drilling or any

other operations.

Please ensure by any means the correct polarity of all connections. Faulty installed and connected

devices may get damage the vehicle and the device permanently.

Please check in any case the operation guide or wiring manual of your amplifier which you'd like to use

for the soundsystem.

Never connect the speaker terminals with the 12 Volt power supply, otherwise the speakers may get

damaged.

HiFonics subwoofer enclosures are designed for high bass levels. Anyhow it is possible, that unsatis-

fying sound characteristics could be caused by too low or too high amplifier power. In certain circum-

stances this even can cause a damage to the loudspeakers.

It is recommended to choose rather a more powerful amplifier (ca. 15-20% more Watts RMS than the

max. RMS power rating of the woofer) and to use the amplifier not at the maximum output level (low

distortion factor, good sound characteristics). A weaker amplifier at the maximum level causes worse

sound characteristics due to the higher distortion factor.

Never crank up the output volume of your amplifier to the maximum level or run the amplifier into the

clipping range. If the sound is distorted and not clean, turn back the level until the distortions disappear.

HiFonics subwoofer enclosures have no integrated limiter or clipper, which is limiting the level upwards.

Overamplified bass peaks leads inevitably to a burn out of the voice coil of the woofer. A burn out of the

voice coil, caused by clipping/overamping is not covered by the usual warranty.

ZRX111P

Subwoofer

Voice Coil

Power Rating

Impedance

Frequency Range

Dimensions

All Specifications are subject to change

28 cm (11")

Ø 64 mm

150 Watts RMS

300 Watts max.

2 + 2 Ohms

20 - 150 Hz

Ø 360 x 145 mm