Autonics ADIO-EI Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник з експлуатації для Системи вводу/виводу Autonics ADIO-EI. Autonics ADIO-EI 10 сторінок. Remote i/o boxes (ethernet/ip)
Друкувати сторінку
Port Connections
■ Port specifications
• Be sure to check the port specifications below before connecting the device. Prepare a cable that complies with the protection rating IP67.
Ethernet port
M12 (Socket-Female), 4-pin,
Type
D-coded
Push-Pull
Number of ports
Tightening torque
0.6 N m
Supported function
Daisy chain
• The example of communication cable for the PDCT port
Connector 1
5-pin
M12 (Plug-Male)
2
1
5
3
4
01. Connect to the EtherNet/IP
02. Connect the IO-Link devices
The maximum output current is 2 A at each I/O port. Configure the device so that the total current of the I/O ports does not exceed 9 A.
Check the wiring information in the manual of the IO-Link device to be connected.
I/O port
M12 (Socket-Female), 5-pin,
A-coded
YES
YES
2
8
0.6 N m
-
Connector 2
Wiring
Connector 1
Pin no.
USB Type A
1
2
1 2
3
4
3
4
5
01. Connect the M12 connector to the Ethernet port. See the connections below.
02. Connect the connector to the EtherNet/IP network.
03. Put the waterproof cover on the unused port.
01. Connect the M12 connector to the I/O port. See the connections below.
02. Put the waterproof cover on the unused port.
PDCT port
M12 (Socket-Female), 5-pin,
A-coded
YES
1
0.6 N m
USB serial communication
Connector 1
Connector 2
Connector 2
Function
Pin no.
Function
N.C.
1
+ 5 VDCᜡ
Data -
→ 2
Data -
0 V
→ 4
0 V
N.C.
-
-
Data +
→ 3
Data +
1
TX +
Transmit Data +
2
RX +
Receive Data +
3
TX -
Transmit Data -
4
RX -
Receive Data -
• Network device: PLC or EtherNet/IP device supporting EtherNet/IP protocol
1
+24 VDCᜡ
1
2
2
I/Q: Digital Input
3
5
4
C/Q: IO-Link, Digital Input/Output
4
3
5
Not Connected (N.C.)
Power supply port
Input: 7/8" (Plug-Male), 5-pin
Output: 7/8" (Socket-Female), 5-pin
N.A
2
1.5 N m
Daisy chain
0 V