Autonnic A5022 Посібник користувача - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник користувача для Морське обладнання Autonnic A5022. Autonnic A5022 12 сторінок. Fluxgate compass

1.3

Switch Inputs

Except for variants with suffix -S, two push-button switches are provided for calibrating the

compass in the field.

When the A5022 is viewed from the front face with the LED facing, then Switch 1 is on the right

and Switch 2 is on the left.

Switch 1:

Switch 2:

upright but at any azimuth. Pressing S2 sets the heading to zero and so can be done

when the whole installation is headed North.

Both together

calibration process to halt and restores the previously saved calibration values.

A blue light indicates three states of the A5022.

State 1

Uncalibrated

State 2

In the process of calibration

State 3

Calibrated

After the reset command,

will have a long flash.

Note that the LED can be turned off and on by the DLED command – see section 5.

Fig 1

Start the auto-calibration process

Set reference NORTH heading. The A5022 must be mounted

Pressing both together for at least one second causes the auto-

long flash

continuous

short flash

$PATC,IIHDG,0CV<CR><LF>

4 of 12

, the A5022 is uncalibrated and