Galvin Specialised Flowmatic TZ-FLOW225866 Інструкція з монтажу виробу - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з монтажу виробу для Аксесуари Galvin Specialised Flowmatic TZ-FLOW225866. Galvin Specialised Flowmatic TZ-FLOW225866 10 сторінок. Wall mounted sensor tap battery operated/single temp
Друкувати сторінку
TROUBLESHOOTING
PROBLEM
INDICATOR
No water
1. Sensor flashes
continuously when user's
coming out of
the faucet:
hands are within the
sensor's range.
2. Led in the sensor does
not flash once user's
hands are within the
sensor's range.
3. Led in the sensor
flashes once when user's
hands are within the
sensor's range.
1. Led in the sensor does
Water flow
not flash once when
from spout
user's hands are within
does not stop:
the sensor's range.
Water flow
diminished
* "Security Mode": If the sensor is covered for more than 90 sec. the faucet will automatically shut off water flow.
To return to normal operation remove any blockage.
** In this case, the water flow will stop anyway after 90 seconds due to the security time.
CAUSE
Low battery.
Range is too short.
Range is too long.
Battery is completely used up
Unit is in "Security Mode" *
Sensor is picking up reflections from
the washbasin or another object.
The water supply pressure is higher
than 500 kPa.
Sensor is dirty or covered. **
Sensor is picking up reflections from
the washbasin or another object.
Filter or aerator is clogged
th
Version 2, 16
March 2021, Page 8 of 9
SOLUTION
Replace battery
Increase the range
Decrease the range
The battery must be replaced.
Eliminate cause of reflection.
Reduce the supply water pressure.
Clean or eliminate cause of
interference.
Decrease the range or eliminate
cause of reflection.
Remove, clean, re-install