AFL ASCEND Інструкція з монтажу

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Мережеве обладнання AFL ASCEND. AFL ASCEND 4 сторінки. Splice cassette
Також для AFL ASCEND: Інструкція з монтажу (4 сторінок)

Друкувати сторінку
ASCEND
SPLICE CASSETTE
™
INSTALLATION INSTRUCTIONS
This document provides installation instructions for the ASCEND Splice Cassette.
MATERIALS
1
3
4
5
INCOMING FIBER PREPARATION (INSIDE PLANT CABLE)
MAIN TRUNK
1.
Measure and ring cut 46" from the end of the main cable trunk.
2.
Remove 4-6" of cable sheath to expose the rip cord and subunits.
3.
Split the cable sheath by pulling the rip cord towards the end of the cable. Remove the split cable sheath.
4.
Remove any loose aramid yarn and rip cords.
5.
Label each sub-unit as necessary.
6.
With the subunits exposed, measure and ring cut 14" from the end of each subunit to expose the fiber.
7.
Ensure sub-unit tubing is located accordingly. Sub-unit tubing should extend just beyond the splice chamber wall when
entering cassette (Figure 1).
1.24.20
1. Cassette Housing with Pigtails
2. Clear Plastic Cover
2
3. Splice Holder Kit
4. Cable Mounting Clip
5. Splice Sleeve Kit
Required Tools: Fusion Splicer, Ring Cutter, Sheers, Tape Measure
46"
CABLE MOUNTING CLIP
12-FIBER SUB UNIT
32"
(800) 235-3423 • (864) 433-0333 • AFLglobal.com
250 µm
14"
Figure 1
1