IKEA Framtid CG7 Інструкція з використання Посібник з використання - Сторінка 4

Переглянути онлайн або завантажити pdf Інструкція з використання Посібник з використання для Духовка. IKEA Framtid CG7. IKEA Framtid CG7 14 сторінок.

Друкувати сторінку

Gas adjustments

Use pressure regulators that are suitable for the gas

pressure values indicated in the Product Description Sheet

supplied separately.

If the appliance is arranged for a type of gas different from that

available, it is necessary to change the injectors, adjust the

minimum flame, change the outlet connector.

Carry out the following operations to change the hob injectors:

remove the grills; remove the burners, the burner caps

(see Fig. 6); change the injector and replace it with one suitable

for the new type of gas (see table in separate Product Sheet).

Replace the gas calibration label with the new label included in the

injector bag.

Refit everything in reverse order, making sure to correctly fit the

burner cap on the burner.

Minimum for hob taps

To adjust the minimum flame, proceed as follows

• Light the burner and turn the knob to minimum

the tap knob (Fig. 7). Insert a small screwdriver next to the tap

pin (Fig. 8).

Turn the adjustment screw anticlockwise to increase the flame,

or clockwise to decrease it. Adjustment is correct when the flame

is approx. 3 - 4 mm.

The adjustment screw must be completely screwed down for

butane/propane gas.

Make sure the flame does not go out when switching suddenly

from high to low

flame

Refit the knob.

Room ventilation

Gas appliances

This appliance is not connected to a fume exhaust device.

Therefore it must be installed and connected in compliance with

current installation regulations.

Particular attention must be paid to the applicable standards

concerning room airing.

Room ventilation

This appliance can only be installed and used in well-ventilated

rooms, according to current regulations, with openings in the

walls or with special ducts enabling proper natural or forced

ventilation, thus ensuring permanent and adequate introduction

of air necessary for correct combustion and for extraction of

vitiated air.

In particular, if there is only this gas appliance in the room, a hood

must be installed above the appliance to ensure natural and direct

extraction of the vitiated air, with a straight vertical duct of length

equal to at least twice the diameter and a minimum section of at

least 100 cm

and vice versa.

; remove

Fig. 6

Fig. 7

Fig. 8