Gamry Interface 5000 Інструкція

Переглянути онлайн або завантажити pdf Інструкція для Випробувальне обладнання Gamry Interface 5000. Gamry Interface 5000 2 сторінки. Installing standard cable on reference 600+
Також для Gamry Interface 5000: Посібник із швидкого старту (4 сторінок)

Друкувати сторінку

Instructions for installing Standard Cable

on Reference 600+

Hardware Deliverables



Calibration Cell (Interface 5000 Calibration Cell/200 Ohm)



60cm Standard Cell Cable (PN 985-00071)

Software Deliverables



IE Correction file (REF600P_CID14.IECOR)

Software Setup

Install the Gamry software as described in the normal documentation. Copy the REF600P_CID14.IECOR

to the following location: C:\ProgramData\Gamry Instruments\Framework\IE Corrections. This folder

may be hidden on some computer, but pasting the above italicized name into Explorer should make it

visible. Please note that for international versions of Windows, the ProgramData folder may be named

slightly different.

Calibration Setup

Connect the 25 pin male end of the 60cm cell cable to the 25 pin female connector on the front of the

Reference 600+. Connect the cell leads of the 60cm cable to the Calibration cell as shown in Figure 1.

Figure 1: Calibration cell showing proper connections.