IKEA FC218 Посібник користувача - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник користувача для Холодильник IKEA FC218. IKEA FC218 20 сторінок. Fridge - freezer
Друкувати сторінку
ENGLISH
Problem
The lamp does not
work.
The compressor oper-
ates continually.
Water flows on the rear
plate of the refrigera-
tor.
Water flows into the re-
frigerator.
Water flows on the
ground.
The temperature in the
appliance is too low/
high.
If your appliance is still not working proper-
ly after making the above checks, contact
the After Sales Centre. You can find the list
at the end of this manual.
Replacing the lamp
Caution! The appliance is equipped
with a longlife LED interior light.
1. Disconnect the plug from the mains
socket.
Possible cause
The lamp is defective.
The temperature is not set
correctly.
The door is not closed cor-
rectly.
The door has been opened
too frequently.
The product temperature is
too high.
The room temperature is too
high.
During the automatic defrost-
ing process, frost defrosts on
the rear plate.
The water outlet is clogged.
Products prevent that water
flows into the water collector.
The melting water outlet does
not flow in the evaporative
tray above the compressor.
The temperature regulator is
not set correctly.
Solution
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product temperature
decrease to room temperature
before storage.
Decrease the room tempera-
ture.
This is correct.
Clean the water outlet.
Make sure that products do
not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Set a higher/lower tempera-
ture.
2. Remove the
screw from
the lamp
cover.
3. Remove the
lamp cover.
4. If needed
replace the
lamp with a
light of simi-
lar characteristic and power. It is sug-
gested to use E14 LED light with maxi-
mum 1,5 Watts.
5. Install the lamp cover.
6. Tighten the screw to the lamp cover.
7. Connect the plug to the mains socket.
12