IKEA IH8362SS0 Інструкція з монтажу та інструкція з експлуатації та догляду - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з монтажу та інструкція з експлуатації та догляду для Вентиляційна витяжка IKEA IH8362SS0. IKEA IH8362SS0 28 сторінок. 36" (91.4 cm) wall-mount canopy range hood
Друкувати сторінку2. Level the blower housing with leveling screws in mounting
hooks, using a level across bottom of blower housing.
3. Remove the metal grease filter and secure the blower
housing with one screw in the bottom hole located in the rear
of the blower.
4_"
Ac__,
B
A. Rear of blower housing
B. Bottom 5 x 35 screw hole
_,_,_o_F_s_'@C_
@
_/s@_ +_
Vented Installations
Only
1. Fit vent system over transition piece.
2. Seal connection with clamps.
Non-vented
(recirculating}
Installation
1. Assemble the 3 parts of the deflector with 2 - 3.5 x 6.5 screws
provided. The assembled deflector should be sized to fit the
width of the vent cover bracket installed earlier.
C
Mc <® Eecff ccl Connec
on
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical
shock.
1. Disconnect
power.
2. Remove terminal box cover.
3. Remove the knockout.
A
S
....
2=
B
A. Vent cover bracket width
B. Deflector
C. 3.5 x 6.5 mm screws
Connect the deflector to the vent cover bracket using
4 - 3.5 x 6.5 screws provided.
A. Knockout
B. Terminal box cover
4. Install the UL listed or CSA approved strain relief.
B
A. Vent cover bracket
B. 3.5 x 6.5 mm screws
3. Measure length of 8" (20.3 cm) vent needed to connect the
transition to the deflector.
NOTE: Vent should fit up inside deflector a minimum of
1" (2.5 cm).
4. Install vent between the transition and the deflector.
5. Seal all connections
with clamps.
F
A. Y2" conduit
B. Terminal box cover
C. UL fisted or CSA approved strain relief
D. Green (or bare) wire connected
to yellow-green
wire
E. White wires
F. Black wires
8