Avantco 178MC49HC Посібник користувача - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник користувача для Кухонна техніка Avantco 178MC49HC. Avantco 178MC49HC 9 сторінок. School milk cooler
Також для Avantco 178MC49HC: Посібник користувача (9 сторінок)

Друкувати сторінку

User Manual

Commercial School Milk Coolers

Inspection

Please read this manual thoroughly prior to equipment set-up, operation and maintenance.

When the equipment is received, all items should be carefully checked against the bill of landing to insure

all crates and cartons have been received. All units should be inspected for concealed damage by uncrating

the units immediately. If any damage is found, it should be reported to the carrier at once, and a claim should

be filed with the carrier. This equipment has been inspected and tested in the Avantco Refrigeration facility

and has been crated in accordance with transportation rules and guidelines. Manufacturer is not responsible

for freight loss or damage.

Installation

General

Take care when removing the skid so that it will not damage the cooler's finish.

Location

The self-contained refrigeration system located at the bottom of the cabinet requires free air access for

proper operation. The back of the cabinet may be positioned against a wall, however, there must be a mini-

mum of four inches of clearance between the sides and a wall. It is necessary to properly level the cooler to

provide adequate drainage and efficient functioning of the unit.

Electrical

Check the proposed outlet to be used to ensure that the voltage, phase, and current carrying capacity of the

circuit from the electrical panel correspond to the requirements of the cabinet. Plug into a standard 120-volt

outlet. NEVER use an extension cord to power any unit. All wiring between the electrical panel and the unit

must be done in accordance with the National Electric Code and all state and local codes. Refer to the Serial

Tag for all pertinent electrical information.

General Operation

The milk coolers are cooled entirely by cold wall because of copper coils completely encircling the perimeter

of the storage compartment. During the refrigeration process, heat is removed through the evaporator tubing

and expelled through the condensing unit. It is important that the flow of air through the side louvers is not

restricted to ensure the condensing unit operates properly. Under normal operating conditions, any frost that

might accumulate on the walls during the "on" cycle of the condensing unit may melt during the "off" cycle.

Drains are installed in all milk coolers to accommodate melting frost. Coolers need to be installed over a floor

drain as there is no catch pan for melting frost.