Align-Pilates C2-Pro Інструкція з монтажу та посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з монтажу та посібник користувача для Фітнес-обладнання Align-Pilates C2-Pro. Align-Pilates C2-Pro 12 сторінок. Reformer
Друкувати сторінку
For the next part we recommend standing the reformer up, with the assistance of
another person, so that they can hold the machine whilst you make the required
adjustments. First make sure that the T bar is in the right position so that the maxi-
mum amount of the chrome bar is showing beneath the head rest. The T bar posi-
tion is changed by loosening the knob and then pulling back to disengage the
locking pin, so that the bar can be slid back or forward. With the T bar correctly
positioned pass the end of each rope through the hole in the end of the T bar
and pull the rope tight. Then knot each rope so that the knot is flush against the
tube as shown in (Fig.17). Repeat for the second rope and then check that the
ropes are adjusted to exactly the same length, if they are not; adjust one of the
knots, the ropes should be taught with the rope handles on the shoulder
rests. When both ropes are the same length and pulled tight, tie an extra
knot in the end of the rope for safety. The ropes tails can be coiled around the T bar to get them out the way.
To adjust the ropes in use, both ropes are simultaneously adjusted using by loosening the adjustment knob under-
neath the head rest and sliding the chrome back in to tighten or pulling it out to loosen the ropes.
8. Foot Strap installation:
1) Separate the strap in to 2 parts. Taking one half of the strap, thread the nylon loop through the eyelet on the re-
former frame under the jump board (Fig. 18)
2) Now pass the foot strap through the loop and pull tight (Fig. 19)
3) Repeat this process for the other half of the strap (Fig. 20) and finally re-thread the strap through the
D-ring (Fig. 17) and the strap is ready to use (Fig.21).
Fig.18
9. How to adjust the foot strap:
To tighten - simply pull on the end of the strap.
To loosen - first loosen the strap at the D-ring and then the strap can be pulled out to be lengthened.
The strap can be used either between the legs (above the cross support and below the jump board) or around the
outside of the jump board, according to your preferred pull position.
10. Adjusting & Locking the Foot Bar
The C2 Pro has a lockable foot bar that uses a locking pin, which is located on
the side of the reformer (see Fig. 22) There is also a place to store the pin when
not in use See Fig. 23 Note: The pin does not completely prevent movement in
a backward direction but it stops a user from falling back when pulling on the
foot bar in a direction away from the standing platform. To raise the foot bar,
first ensure it is unlocked then pull the padded bar towards you stopping at the
desired height. To lower the foot bar it helps if your hold the foot bar selector bar
as well as the padded bar to lower it to the desired height. In either case once
the desired position is achieved you can lock the bar in place with the locking
pin. Note the bar does not lock when it is all the way down. Fig 22 shows the bar
locked and Fig 23 shows the locking pin in the storage position, which keeps the
pin out of the way when not being used to lock the foot bar.
Carriage Stopper
4 Carriage Stopper
Positions
Fig.15
Fig.19
Fig.17
Fig.20
Fig.23
Gear Bar
Fig.16
Fig.21
Fig.22
5