Garmin GPS 16 Посібник із швидкого старту - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Морська система GPS Garmin GPS 16. Garmin GPS 16 16 сторінок. Gps receiver / antenna
Також для Garmin GPS 16: Посібник із швидкого старту (16 сторінок), Декларація про відповідність (1 сторінок)

Installation

Mounting the

GPS 16

Wiring the GPS 16

The ﬁ nal step in installing the GPS 16 is to

connect the receiver' s Port 1 DATA IN, DATA OUT,

REMOTE ON/OFF and GROUND (Return) lines to your

NMEA 0183 device or PC. Port 2 is used for RTCM

input only. The GPS 16 may be plugged directly into a

RJ-45 receptacle, which accepts NMEA 0183 data. It is

recommended that a 1-amp, slow blow fuse be installed

on the power (+) line of the receiving RJ-45 receptacle or

equivalent device. Color coding of the wires is the same

on all GPS 16 models (see wiring diagrams on following

pages). If necessary, the wire coloring on the GPS 16 may

be seen through the clear RJ-45 connector.

For reliable communication, it is essential that the

GPS 16 and the receiving device share the same ground.

This ground connection acts as the (signal) return line.

It is recommended to wire the unit to its own circuit to

avoid interference from other electronics.

Wire Coloring:

1. RED- Power (+)

2. BLACK- Ground (Power (-) and Data Signal Return)

3. YELLOW- Remote power On/Off (Pull low for ON)

4. BLUE- Port 1 NMEA 0183 or GRMN Data Input

5. WHITE- Port 1 NMEA 0183 or GRMN Data Output

6. GREEN- Port 2 RTCM SC-104 Differential Data Input

7. VIOLET- Port 2 Data Output (Reserved for Future Use)

8. GRAY- Pulse Per Second Output (See Tech Speciﬁ cations)

GPS 16

RJ-45 Connector

(Cable View)

6 7