Fujitsu ScanPartner 15C Посібник користувача - Сторінка 18

Переглянути онлайн або завантажити pdf Посібник користувача для Сканер Fujitsu ScanPartner 15C. Fujitsu ScanPartner 15C 23 сторінки. Image scanner
Також для Fujitsu ScanPartner 15C: Технічні характеристики (2 сторінок), Посібник з оновлення (6 сторінок), Посібник користувача (26 сторінок), Інструкції із заміни витратних матеріалів та очищення (7 сторінок), Процедури встановлення (5 сторінок)

4. TROUBLESHOOTING

The Scanner will automatically perform a simple self-test each time it is

turned on. This will help spot major system errors in the Scanner itself.

When the test is initiated, the READY LED is flashing. When the test is

completed, if no error occur, the READY LED is steadily on.

If you have problems with the operation of your Scanner, please check the

following troubleshooting hints.

Question: The LED indicates that the Scanner is ready, but the Scanner

does not respond to the scan command form the host computer.

a) Please check the signal cable is firmly seated,

Answer:

and invoke the scan command again. If there is still no

response,

please reset the Scanner by turning it off and then on again,

and

reboot your host computer as well.

b) Check if the driver is correctly installed. You

DIAG.EXE file in "Fujitsu Driver Kit" to check this out.

c) Try to select another port memory.

Question: Paper becomes jammed during scanning.

a) Open the ADF unit.

Answer:

b) Pull out the jammed paper carefully.

c) Close the ADF unit.

Question: More than one sheet of paper were fed into the Scanner.

Answer: a) Open ADF unit.

b) Remove the multi-fed sheets of paper.

c) Close the ADF unit.

d) Flatten the corners and edges; loosen the paper

before reloading it in the paper guide.

e) Check the feeding roller condition and do the cleaning if

necessary. (See Chapter 3)

4-1

can use the