Brother PS-9000 Посібник користувача - Сторінка 30

Переглянути онлайн або завантажити pdf Посібник користувача для Сервер друку Brother PS-9000. Brother PS-9000 43 сторінки. User manual
Також для Brother PS-9000: Брошура та технічні характеристики (6 сторінок), Посібник користувача (47 сторінок)

Друкувати сторінку

Symptom

If a DHCP/BOOTP server or a

RARP server resides on the

network, the IP address is

automatically issued by the

server. In this case, the IP

address that was manually set

for the PS-9000 may have

been overwritten by the

The print job is

server.

not printed.

If the PS-9000 and the

computer are not in the same

segment, a subnet mask and

gateway address must be set

for the PS-9000.

Depending on the operating

Dial-up starts

system being used, the

when printing

automatic dial-up setting may

is performed.

have been specified.

If the unit stopped operating

because of a tape width error

An error

or no more tape in the cassette

occurs during

during another user's print job,

printing.

printing is not possible until

the error is cancelled.

LPR printing is

With some of the P-touch

not available

machines, LPR printing is not

available.

with PS-9000.

If PT-9500PC is connected to

The tape width

the PS-9000, the tape width

cannot be

detection function of P-touch

detected by

Editor 4 and Quick Editor does

not operate. (There is no tape

P-touch Editor 4

width detection function with

or Quick Editor.

PT-9200DX.)

Can the PS-9000

be initialized

(reset to its fac-

tory default set-

tings)?

Cause

Create a local environment where the server does

not exist and issue the IP address to the PS-9000. At

the same time, make sure that "Obtain an IP address

automatically" in the TCP/IP setting is not marked.

Use the Brother PS-9000 Utility to check whether

the subnet mask and gateway address are correct.

Check the printer port name of the PS-9000. The

port name is indicated by "(PTLAN xxxxxx: P-touch

TCP Port)" after the assigned port name.

When using PS-9000, cancel the setting for

automatic dial-up or, if the automatic dial-up setting

cannot be cancelled, click [Cancel] in the dialup

dialog box to begin printing.

After the other user's print job is finished, try printing

again. Otherwise, use the Web browser to restart

the PS-9000, and then try printing again.

With the PT-9200DX, install the printing software

for the PS-9000 onto each client, and use it instead

of using LPR printing.

Manually specify the tape width.

PS-9000 can be initialized (reset to its factory default

settings) by using the Brother PS-9000 Utility.

Select PS-9000 in the PS-9000 setting dialog box of

the Brother PS-9000 Utility, and then click

[Initialize]. Otherwise, the PS-9000 can be

initialized by pressing the push button. For further

information on how to initialize PS-9000 by pressing

the push button, refer to "Parts and Functions" in

chapter 1, "About PS-9000".

Remedy